Management and Configuration Guide K/KA/KB.15.15

Locates a switch by using the blue locate LED on the front panel.
Blinks the chassis locate LED for a specified number of minutes (Default: 30
min.)
blink 1–1440
Turns the chassis locate LED on for a specified number of minutes (Default:
20 min.)
on 1–1440
Turns the chassis locate LED off.off
Chassislocate at Boot
The chassislocate command has an optional parameter that configures it to run in the future instead
of immediately.
Syntax
chassislocate <on|blink>[Minutes][at startup] chassislocate
off
at Specify when the command is applied (default immediately.)
now Turn on the chassis locate LED immediately.
startup Turn on the chassis locate LED at switch startup.
Example
chassislocate blink 10 at startup
Show locate
Syntax
show system chassislocate
Display
Locator LED Status
Current Time
Member State Remaining Configuration
------ ------- --------- -------------
1 blink 00:27:05 blink 30 at startup
2 on 01:05:27
3 off
Collecting processor data with the task monitor
The task monitor feature allows you to enable or disable the collection of processor utilization data.
The task-monitor cpu command is equivalent to the existing debug mode command
taskusage -d. (The taskUsageShow command is also available.)
When the task-monitor command is enabled, the show cpu command summarizes the
processor usage by protocol and system functions.
Syntax
[ no ] task-monitor cpu
Allows the collection of processor utilization data.
Only manager logins can execute this command.
The settings are not persistent, that is, there are no changes to the configuration.
(Default: Disabled)
304 Monitoring and Analyzing Switch Operation