Management Module Installation Instructions

ManualsBrandsHP ManualsNetwork HardwareHP 5412R zl2 Switch

Management Module Replacement

Instructions

for the HP Series zl Switches Management Modules

The zl Switch Management Modules are designed to be hot-swappable and can be removed without

damage to the switch or the module. However, if multiple management modules are installed in your

switch, the file synchronization may be occurring between them. To minimize the possibility of

corruption between the Management Modules when one is being removed, use the “MM Shutdown”

button on the module you want to remove. Using the “MM Shutdown” button gracefully shuts down

the Management Module, completing any synchronization of files and state information to the second

(standby) Management Module.

Note: If both Management Modules are removed from the switch at the same

time, the switch will shut down.

If there is only one Management Module in the switch, HP recommends replacing the Management

Module, flash disk, or the battery (on the Management module) during the scheduled down time.

1. On the module, unscrew the retaining screws enough to disconnect them from the threaded

holes in the switch.

2. Using the extractor handles, pull the module out from the slot.

3. Remove the flash disk from the failed module and install it into the replacement module.

Note: To replace the flash disk, remove the retaining pin and then replace it

with a new retaining pin. Also, ensure that you push the card in to eject it.

4. Remove the battery from the failed module and dispose of it properly.

5. Install the new battery that came with the replacement module into the replacement module.

Warning: Use only the battery provided with the replacement module. There

would be a risk of explosion, if battery is replaced by an incorrect type.

6. Install the replacement module into the switch.

Summary of content (4 pages)

PAGE 1
Management Module Replacement Instructions for the HP Series zl Switches Management Modules The zl Switch Management Modules are designed to be hot-swappable and can be removed without damage to the switch or the module. However, if multiple management modules are installed in your switch, the file synchronization may be occurring between them. To minimize the possibility of corruption between the Management Modules when one is being removed, use the “MM Shutdown” button on the module you want to remove.
PAGE 2
7. Use an equal amount of pressure and push both extractor handles closed to completely seat the module. 8. Tighten the retaining screws. Figure 1 shows the Management Module removal for an HP 5400R zl2 switch. For a copy of the HP Switch zl Modules Installation Guide, access the HP Networking web site at www.hp.com/networking/support.
PAGE 3
ATTENTION The battery supplied on the management module with this product may contain perchlorate material. Special handling may apply in California and certain other states. See www.dtsc.ca.gov/hazardouswaste/perchlorate Web site for more information. Caution Risk of explosion if battery on the management module is replaced by an incorrect type. Dispose of used batteries according to the instructions.
PAGE 4
© Copyright 2007, 2014 Hewlett-Packard Development Company, LP. All rights reserved. The information contained herein is subject to change without notice. This document contains proprietary information, which is protected by copyright. No part of this document may be photocopied, reproduced, or translated into another language without the prior written consent of Hewlett-Packard. Technical information in this document is subject to change without notice.