Multicast and Routing Guide K/KA/KB.15.15

Event log messages
MeaningMessage
The mask entered for the specified multicast address does
not specify sufficient bits to include the nonzero bits in the
mask.
multicast-addr / mask Inconsistent
address and mask.
A PIM packet was received that does not have a neighbor..
pkt-type pkt, src IP
[ip-addr] vid [vid-#] (not a nbr)
The PIM packet was dropped because of a bad parameter
in the packet from the IP address shown.
Bad parameter-name in pkt-type
pkt from IP ip-addr
A BSM send failed. The IP address shown is the BSM
destination address.
BSM send to ip-addr failed
Candidate BSR functionality has been disabled.
Candidate BSR functionality
disabledpkt-type
C-RP functionality has been disabled.
C-RP functionality disabled
A C-RP advertisement send failed. The IP address shown
is the destination address of the message.
C-RP advertisement send to ip-addr failed
Candidate BSR functionality has been enabled at the
indicated IP address.
Enabled as Candidate BSR using address:
ip-addr
C-RP functionality has been enabled at the indicated IP
address.
Enabled as C-RP using address: ip-addr
Hardware resources are consumed and software routing
is being done for the flow.
Failed alloc of HW flow for flow
src-ip-addr , multicast-addr
The IP address manager PIM callback routine failed to
initialize.
Failed to initialize pkt-type as a call
back routine
Allocation of a packet buffer failed message.
Failed to alloc a pkt-type pkt (vid vid-#
)
The IP address on the PIM interface has changed to the
indicated address.
I/F configured with IP ip-addr on vid
vid-#
The PIM interface has been removed because of IP address
removal or change of the indicated IP address.
I/F removal with IP ip-addr on vid vid-#
An illegal state/event combination has been detected in
the BSR state machine.
Illegal operation in BSR state machine
The switch received a malformed C-RP-advertisement.
Malformed C-RP adv recvd from ip-addr
The indicated interface could not join the multicast group
for PIM packets.
MCAST MAC add for mac-addr failed
A multicast flow has been dropped due to low resources
MCAST flow src-ip-addr , multicast-addr
not rteing (rsc low)
The multicast hardware cannot be enabled.
Multicast Hardware Failed to initialize
An IP address is not configured for the indicated interface
enabled with PIM.
No IP address configured on VID vid-#
PIM was unable to find a route to the specified IP address.
No route to source/rp ip-addr
PIM-SM needed an RP for the indicated group address,
but none was found.
No RP for group ip-addr
Event log messages 105