Multicast and Routing Guide K/KA/KB.15.15

Table 8 IP global parameters for routing switches (continued)
See pageDefaultDescriptionParameter
NOTE: You also can
enable or disable this
parameter on an individual
interface basis. See Table 9
(page 116).
A-21
A-159
DisabledAn IP protocol that a router
can use to advertise the IP
ICMP Router Discovery
Protocol (IRDP)
addresses of its router
interfaces to directly
attached hosts. You can
enable or disable the
protocol at the Global CLI
Config level.
You also can enable or
disable IRDP and configure
the following protocol
parameters on an individual
VLAN interface basis at the
VLAN Interface CLI Config
level.
• Forwarding method
(broadcast or multicast)
• Hold time
• Maximum advertisement
interval
• Minimum advertisement
interval
• Router preference level
A-25No entriesAn IP route you place in the
IP route table.
Static route
A-30None configuredThe router uses the default
network route if the IP route
Default network route
table does not contain a
route to the destination.
Enter an explicit default
route (0.0.0.0 0.0.0.0 or
0.0.0.0/0) as a static route
in the IP route table.
IP interface parameters for routing switches
Table 9 (page 116) lists the interface-level IP parameters for routing switches.
Table 9 IP interface parameters — routing switches
See pageDefaultDescriptionParameter
1
None configuredA Layer 3 network interface
address; separate IP
IP address
addresses on individual
VLAN interfaces.
A-331 (one)A numeric cost the router
adds to RIP routes learned
Metric
on the interface. This
parameter applies only to
RIP routes.
116 Routing Basics