Multicast and Routing Guide K/KA/KB.15.15

Auto-summary Status of auto-summary for all interfaces
running RIP. If auto-summary is enabled,
subnets will be summarized to a class
network when advertising outside of the
given network.
Default metric Sets the default metric for imported routes.
This is the metric that will be advertised with
the imported route to other RIP peers. A RIP
metric is a measurement used to determine
the "best" path to network: 1 is the best, 15
is the worst, 16 is unreachable.
Route changes The number of times RIP has modified the
routing switch’s routing table.
Queries The number of RIP queries that have been
received by the routing switch.
RIP interface information RIP information on the VLAN interfaces on
which RIP is enabled:
IP address Address of the VLAN
interface running RIP.
Status Status of RIP on the VLAN
interface.
Send mode Format of the RIP updates:
RIP 1, RIP 2, or RIP 2
version 1 compatible.
Recv mode The switch can process RIP
1, RIP 2, or RIP 2 version
1 compatible update
messages.
Metric Path "cost," a
measurement used to
determine the "best" RIP
route path: 1 is the best,
15 is the worst, 16 is
unreachable.
Auth RIP messages can be
required to include an
authentication key if
enabled on the interface.
RIP peer information RIP peers are neighboring routers from which
the routing switch has received RIP updates:
IP address IP address of the RIP neighbor.
Bad routes Number of route entries which were not
processed for any reason.
Last update timeticks Number of seconds that have passed since we
received an update from this neighbor.
Viewing RIP interface information
To display RIP interface information, enter the show ip rip interface command at any
context level.
134 Routing Information Protocol