Multicast and Routing Guide K/KA/KB.15.15

Example 94 General output for the show ip ospf command
HP Switch(config)# show ip ospf general
OSPF General Status
OSPF protocol : enabled
Router ID : 17.255.134.231
RFC 1583 compatability : compatible
Intra-area distance : 110
Inter-area distance : 110
AS-external distance : 110
Default import metric : 10
Default import metric type : external type 2
Area Border : no
AS Border : no
External LSA Count : 0
External LSA Checksum Sum : 0
Originate New LSA Count : 0
Receive New LSA Count : 0
Graceful Restart Interval : 120
Graceful Restart Strict-Lsa Checking : Enabled
Nonstop forwarding : Disabled
Log Neighbor Adjacency Changes : Enabled
SPF Throttling
Start Interval : 3
Wait Interval : 3
Maximum Wait Time : 500
Current Wait Interval : 3
The show running-config command also displays the SPF configuration information. The
configured parameters for SPF are highlighted in bold below.
HP Switch(config)# show running-config
Running configuration:
; J8693A Configuration Editor; Created on release #K.15.07.0000x
; Ver #01:2f:2e
hostname "HP Switch"
module 1 type J86yyA
module 2 type J86xxA
vlan 1
name "DEFAULT_VLAN"
untagged 1-4,7-48,A1-A4
ipv6 address fe80::2 link-local
ip address dhcp-bootp
ipv6 enable
no untagged 5-6
exit
power-over-ethernet pre-std-detect
router ospf
spf-throttle start-interval 3 wait-interval 3 max-wait-time 500
exit
snmp-server community "public" unrestricted
Viewing OSPF information 167