Multicast and Routing Guide K/KA/KB.15.15

Table 14 CLI display of OSPF area information (continued)
ContentField
Metric for the default route that the routing switch will inject into a stub area
if the routing switch is an ABR for the area. This value applies only to stub
areas.
Cost
Number of times the routing switch has run the shortest path first route
calculation for this area.
SPFR
Number of area border routers in this area.ABR
Number of autonomous system border routers in this area.ASBR
Number of LSAs in the link state database for this area.LSA
Sum of the checksums of all LSAs currently in the area's link state database.
This value can be compared to the value for other routers in the area to verify
database synchronization.
Chksum(Hex)
Example
Example 95 show ip ospf area output
HP Switch(config)# show ip ospf area
OSPF Area Information
Area ID Type Cost SPFR ABR ASBR LSA Checksum
--------------- ------ ----- ------ ---- ---- ----- ----------
0.0.0.0 normal 0 1 0 0 1 0x0000781f
192.147.60.0 normal 0 1 0 0 1 0x0000fee6
192.147.80.0 stub 1 1 0 0 2 0x000181cd
Viewing OSPF external link-state information
Syntax:
show ip ospf external-link-state
When you enter this command, an output similar to the following is displayed:
Example 96 Output for the show ip ospf external-link-state command
HP Switch# show ip ospf external-link-state
OSPF External LSAs
Link State ID Router ID Age Sequence # Checksum
--------------- --------------- ---- ----------- ----------
10.3.7.0 10.0.8.37 232 0x80000005 0x0000d99f
10.3.8.0 10.0.8.37 232 0x80000005 0x0000cea9
10.3.9.0 10.0.8.37 232 0x80000005 0x0000c3b3
10.3.10.0 10.0.8.37 232 0x80000005 0x0000b8bd
10.3.33.0 10.0.8.36 1098 0x800009cd 0x0000b9dd
Table 15 (page 170) shows the information the OSPF external link state displays:
Viewing OSPF information 169