Multicast and Routing Guide K/KA/KB.15.15

Example
Example 98 Output for show ip ospf interface
HP Switch# show ip ospf interface
OSPF Interface Status
IP Address Status Area ID State Auth-type Cost Pri Passive
--------------- -------- -------------- ------- --------- ------ --- -------
10.3.18.36 enabled 10.3.16.0 DOWN none 1 1 no
10.3.53.36 enabled 10.3.48.0 BDR none 1 1 no
Example 99 OSPF interface configuration
Admin Authen
IP Address Area ID Status Type Type Cost Pri
--------------- --------------- -------- -------- ------ ----- ---
172.16.30.186 backbone enabled Pt-to-Pt none 100 n/a
Viewing OSPF interface information for a specific VLAN or IP address
Syntax:
show ip ospf interface [ vlan vlan-id | ip-addr ]
To display OSPF interface information for a specific VLAN or IP address, enter the
show ip ospf interface ip-addr command at any CLI level.
Table 17 CLI display of OSPF interface information—VLAN or IP address
ContentField
Will always be BCAST for interfaces on this routing switch. Point-to-point
or NBMA (frame relay or ATM) type interfaces are not supported on the
switches.
Type
Configured transit delay for this interface.Transit Delay
Configured retransmit interval for this interface.Retrans Interval
Configured hello interval for this interface.Hello Interval
Configured router dead interval for this interface.Rtr Dead Interval
Set the network type for this interface, point-to-point or broadcast.Network Type
IP address of the router that has been elected DR on this interface.Designated Router
IP address of the router that has been elected BDR on this interface.Backup Desig. Rtr
Number of times the interface state has changed.Events
Whether the interface sends LSAs to all other routers in the same Autonomous
System (AS.)
Passive
Number of neighbors.Neighbors
If you use show ip ospf interface vlan vlan-id, the output is the same
as shown in the previous table, except for the IP address on the indicated VLAN.
172 Open Shortest Path First Protocol (OSPF)