Multicast and Routing Guide K/KA/KB.15.15

Allows you to specify a time in seconds that this router will wait before taking control
of the VIP and beginning to route packets. You can configure the timer on VRRP
owner and backup routers.
NOTE: If you have configured the preempt delay time (PDT) with a non-zero value,
you must use the no form of the command to change it to 0 (zero.)
Default: 0 (zero) seconds.
Viewing VRRP configuration data
Viewing the VRRP global configuration
Syntax:
show vrrp config global
Displays the configuration state for the global VRRP configuration and VRRP trap
generation.
Example 148 Output showing the default global VRRP configuration (IPv4/IPv6)
HP Switch(config)# show vrrp config global
VRRP Global Configuration Information
VRRP Enabled : No
Traps Enabled : Yes
Virtual Routers Responde to Ping Requests : No
VRRP Nonstop Enabled : No
Viewing all VR configurations on the router
Syntax:
show vrrp config
Displays the configuration for the global VRRP configuration and all VRs configured
on the router.
264 Virtual Router Redundancy Protocol (VRRP)