Multicast and Routing Guide K/KA/KB.15.15

Example 151 Displaying the IPv4 configuration for a specific VR
The following command displays the configuration of a VR identified as VR 10 in VLAN 23:
HP Switch(config)# show vrrp vlan 23 vrid 10 config
VRRP Virtual Router Configuration Information
Vlan ID : 23
Virtual Router ID : 10
Administrative Status [Disabled] : Disabled
Mode [Uninitialized] : Owner
Priority [100] : 255
Advertisement Interval [1] : 1
Preempt Mode [True] : True
Prempt Delay Time [0] : 0
Respond to Virtual IP Ping Requests [Yes} : Yes
Verson [2] : 2
Null authentication compatibility [False] : False
Primary IP Address : Lowest
IP Address
---------------
10.10.10.1
Example 152 Displaying the IPv6 configuration for a specific VR
HP Switch# show vrrp ipv6 vlan 10 vrid 4 config
VRRP Virtual Router Configuration Information
VLAN ID : 10
Virtual Router ID : 1
Administrative Status [Disabled] : Enabled
Mode [Uninitialized] : Owner
Priority [100] : 255
Advertisement Interval [1] : 1
Preempt Mode [True] : True
Preempt Delay Time [0] : 0
Respond To Virtual IP Ping Requests [Yes] : Yes
Version [2] : 3
IPv6 Address
---------------------------
fe80::216:b9ff:fed1:5280
Viewing VRRP statistics data
All command outputs shown in this section assume that VRRP is enabled at the global configuration
level. If global VRRP is disabled, these commands produce the following output:
Viewing VRRP configuration data 267