Multicast and Routing Guide K/KA/KB.15.15

Example
Example 159 The show vrrp command with statistics
Near Failovers statistic displayed is shown in bold below.
HP Switch(config)# show vrrp
VRRP Global Statistics Information
VRRP Enabled : Yes
Invalid VRID Pkts Rx : 0
Checksum Error Pkts Rx : 0
Bad Version Pkts Rx : 0
Virtual Routers Respond to Ping Requests : No
VRRP Virtual Router Statistics Information
Vlan ID : 22
Virtual Router ID : 1
Protocol Version : 2
State : Initialize
Up Time : 64 mins
Virtual MAC Address : 00005e-000101
Master's IP Address : 10.10.20.2
Associated IP Addr Count : 1 Near Failovers : 0
Advertise Pkts Rx : 0 Become Master : 0
Zero Priority Rx : 0 Zero Priority Tx : 0
Bad Length Pkts : 0 Bad Type Pkts : 0
Mismatched Interval Pkts : 0 Mismatched Addr List Pkts : 0
Mismatched IP TTL Pkts : 0 Mismatched Auth Type Pkts : 0
Example 160 The show vrrp ipv6 statistics command
HP Switch# show vrrp ipv6 statistics
VRRP Global Statistics Information
VRRP Enabled : Yes
Invalid VRID Pkts Rx : 0
Checksum Error Pkts Rx : 0
Bad Version Pkts Rx : 0
Virtual Routers Respond To Ping Requests : Yes
VRRP Virtual Router Statistics Information
VLAN ID : 10
Virtual Router ID : 1
Protocol Version : 3
State : Master
Up Time : 26 mins
Virtual MAC Address : 00005e-000101
Master's IP Address : 2130::21
Associated IP Addr Count : 1 Near Failovers : 0
Advertise Pkts Rx : 0 Become Master : 1
Zero Priority Rx : 0 Zero Priority Tx : 0
Bad Length Pkts : 0 Bad Type Pkts : 0
Mismatched Interval Pkts : 0 Mismatched Addr List Pkts : 0
Mismatched IP TTL Pkts : 0 Mismatched Auth Type Pkts : 0
Using the debug command with the VRRP option
The vrrp option with the debug command turns on the tracing of the incoming and outgoing
Using the debug command with the VRRP option 273