Multicast and Routing Guide K/KA/KB.15.15

Example 26 Output for routing switch "#1" in Figure 8 (page 44)
HP Switch(config)# show ip pim interface 29
PIM Interface
VLAN : 29
IP Address : 10.29.30.1
Mode : dense
Hello Interval (sec) : 30
Hello Delay (sec) : 5
Graft Retry Interval(sec) : 3
Max Graft Retries : 2
Override Interval (msec) : 2500 Lan Prune Delay
: Yes
Propagation Delay (msec) : 500 Lan Delay Enabled
: No
SR TTL Threshold : 2 State Refresh Capable
: No
Table 5 PIM interface configuration settings
Control commandDefaultField
vlan vid ip pim-denseN/AVLAN
vlan vid ip pim-dense any | ip-addrN/AIP
PIM-dense or PIM-sparsedenseMode
ip pim-dense hello interval 5 - 3030Hello interval
(sec)
The routing switch computes this value from the current hello interval and includes it in the hello
packets the routing switch sends to neighbor routers. Neighbor routers use this value to determine
105Hello hold
time
how long to wait for another hello packet from the routing switch. See the description of the
hello interval on (page 39).
vlan vid ip pim-dense hello delay 0 - 55Hello delay
vlan vid ip pim-dense graft-retry-interval 1 - 103Graft retry
interval (sec)
vlan vid ip pim-dense graft-retries 1 - 102Max graft
retries
vlan vid ip pim-dense override-interval 500 - 60002500Override
interval
(msec)
vlan vid ip pim-dense propagation-delay 250-2000500Propagation
delay (msec)
vlan vid ip pim-dense ttl-threshold 0 - 2550SR TTL
threshold
(router hops)
vlan vid ip pim-dense lan-prune-delayYesLAN prune
delay
Shows
[Yes]
NoLAN delay
enabled
if all multicast routers on the current VLAN interface enabled LAN-prune-delay. Otherwise,
shows
[No]
Indicates whether the VLAN responds to state-refresh packets. The VLAN connected to the
multicast source does not receive state-refresh packets and thus is not state-refresh capable.
Downstream VLANs in the switches are state-refresh capable.
N/AState-refresh
capable
52 PIM-DM (Dense Mode)