Event Log Message Reference Guide 2013/06

15
Event Log Messages
265 Lost communication with Mgmt
Module <mod-num>
warning A management module failed to receive heartbeats from the other
management module.
RMON_SYSTEM_MGMT_LOST_COMM
266 Resetting Mgmt Module <mod-
num>
info The specified management module is reset. This can occur if you
perform a boot standby command or for other reasons when an
individual module is rebooted.
RMON_SYSTEM_MGMT_RESET
267 Mgmt Module <mod-num>-
Running different version of SW
info The specified management module is running a different version
of software from the other management module.
RMON_SYSTEM_MGMT_OS_DIFF
268 Mgmt Module <mod-num> -
Failover occurred
warning A switchover occurred because of a hardware or software failure
or because the management module reset button was pressed.
RMON_SYSTEM_MGMT_FAILOVER
269 Mgmt Module <mod-num>] -
User initiated switchover
occurred
info The user has initiated switchover using the redundancy
switchover command so that the other management module can
become the active management module.
RMON_SYSTEM_MGMT_SWITCHOVER
270 Mgmt Module <mod-num>-
Offline (incompatible SW
versions)
warning The software version in the specified management module is not
compatible with the other module and it has gone offline.
RMON_SYSTEM_MGMT_INCOMPAT_OS
271 Other management module is not
in standby, shutdown request
ignored
warning A shutdown request is ignored because the standby module is not
in standby mode. A management module must be in active or
standby mode to be shut down. The module goes into a “down”
state which allows you to safely swap it out.
RMON_SYSTEM_MGMT_HSBUTTONERR
272 Mgmt Module <mod-num>
Offline (shutdown)
info The specified management module is offline because of a
shutdown.
RMON_SYSTEM_MGMT_SHUTDOWN
273 Resetting Mgmt Module <mod-
num> <reason for reset>
info The indicated management module is being reset for the reason
displayed.
RMON_SYSTEM_MGMT_RESET_REASON
274 Slot <slot-num> self test failure
or unsupported module.
warning The specified slot failed self-test. There may be an unsupported
module in the slot.
RMON_CHASSIS_SLOT_FAIL
275 STP not enabled - multiple
VLANS defined
warning STP was not enabled because multiple VLANs are defined.
RMON_STP_MULTI_VLANS
276 testmode: Internal use only. DO
NOT PUBLISH
info Test mode
RMON_TESTMODE_INFO
277 testmode: Internal use only. DO
NOT PUBLISH
warn Test mode
RMON_TESTMODE_WARN
# Message Severity Description