Event Log Message Reference Guide 2013/06

18
Event Log Messages
315 NULL Domain name passed for
target IP <ip-addr>
warning There was no domain name given to the target IP address.
RMON_IGMP_PROXY_NULL_DOMAIN_NAME
316 VLAN ID out of range <vlan-id> warning The VLAN ID requested is not within the range of valid values.
RMON_IGMP_PROXY_BAD_VLAN
317 BAD Target IP address <ip-addr> warning Bad target IP address.
RMON_IGMP_PROXY_BAD_TARGET
318-
322
— — Reserved
RMON_UNUSED_318 - 322
323 VLAN <vlan-id> defined but not
active
info The VLAN has been configured but is not active.
RMON_VLAN_NOT_ACTIVE
324 Port <port-num> is member of an
invalid VLAN <vlan-id>
warning The port is a member of an invalid VLAN.
RMON_VLAN_INVALID_MEMBER
325 Port initialization failed for port
<port-num>
warning Initialization failed on the specified port.
RMON_PMGR_INVALID_PORT
326 Port <port-num>: Xcvr not
supported in current OS
warning The transceiver in the specified port is not supported with the
current software version.
RMON_PPMGR_XCVR_INVALID
327 Port <port-num> - Excessive
undersized/giant packets. See
help.
info An excessive number of undersized or giant packets were
received on the specified port. Refer to the help information for
more details.
RMON_FF_BAD_DRIVER_NIC
328 Port <port-num> - Excessive
jabbering. See help.
info A device on this port is incessantly transmitting packets
(“jabbering” is detected as oversized packets with CRC errors) or
transmitting excessive fragments.
Possible causes: A misconfigured NIC, or a malfunctioning NIC or
transceiver. It could also be caused by a short-circuit in the
network cable path.
Actions:
1. Check the NIC for a misconfiguration.
2. Update the NIC firmware.
3. UPdate the NIC driver software.
4. Replace the NIC or transceiver.
5. Check for a short-circuit in the cable path connected to this
port.
RMON_FF_BAD_XCVR_NIC
329 Port <port-num> - Excessive
CRC/alignment errors. See help.
info An excessive number of cyclic redundancy check (CRC) or
alignment errors were reported on the specified port. Refer to the
help information for more details.
RMON_FF_BAD_CABLE
330 Port <port-num> - Excessive late
collisions.
info An excessive number of late packet collisions have been reported
on the specified port.
RMON_FF_CABLE_LEN_HOPS
# Message Severity Description