Event Log Message Reference Guide 2013/06

30
Event Log Messages
525 Multiple send keys for current
daytime
warning Multiple key chain entries are active to transmit packets during
this time period.
RMON_KMS_TX_KEY_OVERLA
526 Bad reference warning Key request does not correspond to configured key chain entries.
RMON_KMS_GEN_ERROR
527-
531
— — Reserved
RMON_KMS_RESERVED_0 - 4
532 Port <port-num> Unsupported
transceiver. (SelfTest Err)
Check: www.hp.com/rnd/
device_help/2_inform for more
info.
warning The transceiver installed in the port failed self-test and is not
supported.
RMON_XCVR_CTRFT0
533 Port <port-num> Not a ProCurve
transceiver. Please go to: \
www.hp.com/rnd/device_help/
2_inform for more info.
warning The transceiver installed in the port is not a ProCurve device.
RMON_XCVR_CTRFT1
534 Port <port-num> transceiver type
not supported in this software\
version. Please check for an
updated release.
warning The transceiver type installed in the port is not supported in this
software release.
RMON_XCVR_CTRFT2
535 Port <port-num> This switch only
supports revision B and above
transceivers.
warning The transceiver installed in the port is not supported. The switch
supports only revision B (or later) transceiver types.
RMON_XCVR_CTRFT3
536 Port <port-num> transceiver type
not supported in this port.
warning The transceiver type installed in the port is not supported in this
port.
RMON_XCVR_CTRFT4
537 Syncing [primary |secondary] OS
to standby [started | completed]
info This message is logged when the OS begins synchronizing to the
standby module. It displays the status of the synchronization.
RMON_SYSTEM_OS_SYNC
538 Standby <boot image | default
boot> updated, rebooting
standby
info This message is logged when the standby’s management module
boot image is overwritten, requiring a reboot.
RMON_SYSTEM_STANDBY_REBOOT
539 Initial active to standby sync
<started | completed>
info Indicates the beginning or end of the initial synchronization of the
active management module’s flash image to the standby
management module.
RMON_SYSTEM_INITIAL_SYNC
540 Redundant Standby
Management Module syncing is
<module>. Configuration
changes are <changes>.
info The redundant management module is syncing. Configuration
changes are temporarily disabled.
RMON_SYSTEM_INITIAL_SYNC_BLOCK_CONFIG
541 Out of storage space on standby info The standby switch is out of storage space.
RMON_SYSTEM_MODULE_DISK_FULL
# Message Severity Description