Event Log Message Reference Guide 2013/06

36
Event Log Messages
609 Pkt dropped from <ip-addr>,
(<cause>), vid <vlan-id>
info A PIM packet from the specified IP address was dropped due to
one of the following causes:
• No PIM interface on the VLAN
• Bad packet length
• Bad IP header length
• Bad IP total length
RMON_PIM_PKT_DROPPED
610 Pkt rcvd with a cksum error from
<ip-addr>
info A packet having a checksum error was received from the
specified IP address. Check the cabling and ports on the local and
the remote routers.
RMON_PIM_PKT_CKSUM_ERR
611 Rcvd pkt ver# <ver-num>, from
<ip-addr>, expected <ver-num>
warning The versions of PIM-DM on the sending and receiving routers do
not match. Differing versions will typically be compatible, but
features not supported in both versions will not be available.
RMON_PIM_PKT_VER_MISMATCH
612 Rcvd pkt from rtr <ip-addr>,
unkwn pkt type <value>
warning A packet received from the router at the specified IP address is
an unknown PIM packet type. (The <value> variable is the
numeric value received in the packet.)
RMON_PIM_PKT_TYPE_UNKNOWN
613 MCAST MAC add for <mac-
addr> failed
warning Indicates a hardware problem. Check the cabling and router
ports.
RMON_PIM_CANNOT_JOIN_MCAST_DEST
614 MCAST flow <mcast-addr> <src-
ip-addr> not rteing (rsc low)
warning The indicated multicast flow is not routing. The routing switch is
low on memory resources as a result of too many flows for the
number of configured VLANs. Remedies include one or more of
the following:
• Reduce the number of configured VLANs by moving some
VLANs to another router.
• Free up system resources by disabling another feature, such
as one of the spanning-tree protocols or either the RIP or the
OSPF routing protocol. (Unless you are using static routes, you
will need to retain a minimum of one unicast routing protocol.)
Another option that may help is to reduce the number of
configured QoS filters.
• Move some hosts that create multicast demand to another
router.
RMON_PIM_LOW_MEM_MCAST_FLOW
615 No IP address configured on VID
<vlan-id>
fatal PIM has detected a VLAN without an IP address. Configure an IP
address on the indicated VLAN.
RMON_PIM_IP_NOT_CONFIG
616 Multicast Hardware Failed to
initialize
fatal Indicates a hardware failure that halts hardware processing of
PIM traffic. The software will continue to process PIM traffic at a
slower rate. Contact your ProCurve customer care center.
RMON_PIM_MCAST_ROUTING_HW_FAILURE
# Message Severity Description