Event Log Message Reference Guide 2013/06

46
Event Log Messages
753 Static RP configuration failure:
<src-ip-addr>, <mcast-addr>
warning The configuration of a static RP for the specified multicast group
has failed on the interface.
RMON_PIM_BSR_STATIC_RP_CONFIG_FAIL
754 Malformed Candidate-RP adv
recvd from <ip-addr>
warning The switch received a malformed C-RP-advertisement.
RMON_PIM_BSR_MALFORMED_CRP_ADV
755 Failed flow remove: vid <vid>
<multicast group ip-addr>
<multicast source ip-addr>
info The switch failed to delete a flow programmed into hardware.
RMON_PIM_HW_REMOVE_FAIL
756-
769
Reserved
RMON_PIM_BSR_UNUSED_2 - 16
770 Failed to alloc msg buffer for
<routine-name> event
standard A message buffer could not be allocated in the specified routine.
RMON_VRRP_NO_MSG_BUF
771 Unable to add MCAST address
<mcast-addr>
fatal Initialization failed because the specified VRRP multicast receive
address could not be set up.
RMON_VRRP_CANNOT_ADD_MCAST_DEST
772 Illegal event/state combination
called
warning VRRP received an illegal event/state combination.
RMON_VRRP_ILLEGAL_EVENT_STATE_ERROR
773 Pkt rcvd that was too short, len =
<bytes>, min = <bytes>
warning A VRRP packet of the specified length was received, which is less
than the minimum supported packet size.
RMON_VRRP_PKT_TOO_SHORT
774 Vrid <vr-id>, Vid <vlan-id> recd
pkt with checksum error
warning The VR on the specified VLAN has received a VRRP advertisement
packet with a checksum error. The VR has therefore dropped that
packet.
RMON_VRRP_CHECKSUM_ERROR
775 Pkt rcvd with version number
<ver-num>, expected <ver-num>
warning A VRRP packet was received with a wrong version number.
RMON_VRRP_VER_MISMATCH
776 No VR with vrid <vr-id> found on
vid <vlan-id>
warning Indicates a VRRP packet received for a VR that does not exist on
the VLAN. This can indicate asymmetric configuration of VRs
across VRRP routers.
RMON_VRRP_NO_VR_ON_VID
777 Vrid <vr-id>, Vid <vlan-id> recd
pkt with bad IP-TTL
warning A VRRP packet was received by the VR on the specified VLAN
with an IP TTL value not equal to 255.
RMON_VRRP_PKT_RECD_WITH_BAD_TTL
778 Vrid <vr-id>, Vid <vlan-id> recd
pkt with auth type mismatch
warning Indicates the VR has received a packet with the auth type
mismatch authentication type set to 1 or 2. These are generally
valid authentication types, but are not required by RFC 3768. Thus,
the software supports only an authentication type of 0 (zero), and
VRRP packets with 1 or 2 for authentication type are dropped. For
more information, refer to the “Operating Notes” section in the
“Virtual Router Redundancy Protocol (VRRP)“ chapter of the
Multicast and Routing Guide.
RMON_VRRP_AUTH_TYPE_MISMATCH
# Message Severity Description