Event Log Message Reference Guide 2013/06

53
Event Log Messages
869 Ceasing removed lease logs for
<duration>
warning Removed lease logs will not be logged for the specified duration.
The dsnooping table is full.
RMON_DSNOOP_TABLE_FULL_REM_LEASE_SUSP
870 Drop request from <mac-addr>
for <ip-addr> because the
address is assigned to another
client
warning The client is requesting an IP address that is already in use by a
different client in the same VLAN. The request from the indicated
MAC address is dropped.
RMON_DSNOOP_BAD_IP_REQ
871 Ceasing status logs for Duplicate
IP request for <duration>
warning Status logs are not being continued. The duration can be in
seconds, for example, “5s”, or minutes, for example “5m”.
RMON_DSNOOP_BAD_IP_REQ_SUSP
872 RMON <file-type> file corrupt, is
being deleted
warning The RMON alarms or events file is corrupt and will be deleted.
RMON_SNMP_REMOVE_CORRUPT_FILE
873-
882
— — Reserved
RMON_SNMP_UNUSED_1 - 10
883 Port failure. Port <port-num> has
been reset.
warning The failed port has now been reset and is operational.
RMON_FF_DEAD_PHY
884 Port <port-num> disabled - loop
detected.
warning A loop on the port has been detected. The port is disabled.
RMON_LOOP_PROTECT_DISABLE_PORT
885 Port <port-num> disabled - trunk
is disabled.
warning The port was disabled by loop protection because it was added
to a trunk that has been disabled by loop protection.
RMON_LOOP_PROTECT_DISABLE_TRUNKED_PORT
886 Port <port-num> - loop detected. info A loop on the switch has been detected on the specified port by
the loop protection protocol. The port was not disabled because
the loop protection packet was received on a port that is
configured to not disable other ports.
RMON_LOOP_PROTECT_LOOP_DETECTED
887 Port <port-num> - disabled
period expired.
info The disable period for the port has expired and an attempt was
made by loop protection to re-enable the port.
RMON_LOOP_PROTECT_ENABLE_PORT
888 Port <port-num> - received
packet failed authentication.
info Loop protection packets on the port are not being processed
because they are not authentic. This can happen if a malicious
user is trying to spoof loop protection packets.
RMON_LOOP_PROTECT_SECURITY_AUTH_FAILED
889 port <port-num> continuous loop
detected; manually disable port
to stop this message
info Loop protection has repeatedly detected a loop on the specified
port and the port should be disabled.
RMON_LOOP_PROTECT_CONTINUOUS_LOOP
890 Flow-control and sFlow sampling
now enabled. Egress-sampling
being disabled.
info Because flow control and sampled flow are now enabled, egress
sampling has been disabled. (Egress sampling is disabled even if
sampled flow is not enabled.)
RMON_SFLOW_DISABLE_EGRESS
891 Flow-control is disabled. Re-
enabling sFlow egress-sampling.
info Because flow control is now disabled, egress sampling has been
re-enabled. (Egress sampling is re-enabled even if sampled flow
is is not enabled.)
RMON_SFLOW_ENABLE_EGRESS
# Message Severity Description