Event Log Message Reference Guide 2013/06

54
Event Log Messages
892-
896
— — Reserved
RMON_SFLOW_UNUSED_1 - 5
897 The existing config requires
changing default for parameter:
<parameter>
info You must change the default for the parameter indicated, for this
configuration.
RMON_CFG_INIT_OVERRIDE_DEFAULT
898 LP Manager s has disabled port
<port-num> for <num-secs>
seconds
info The specified port has been disabled for the indicated number of
seconds by LP Manager.
RMON_LPMGR_DISABLE_TIMEOUT
899 LP Manager has disabled port
<port-num>
warning LP Manager has disabled the indicated port with no timeout.
RMON_LPMGR_DISABLE_INFINITE
900 port <port-num> time requested
by LP Manager has expired.
info The port disable timer has expired.
RMON_LPMGR_TIMEOUT_EXPIRED
901 Failed to allocate new <route
table information> entry
warning New <route table information> was not allocated.
RMON_IPADDRMGR_ENTRY_ALLOC_FAIL
902 Failed to deallocate <route table
information> entry
warning <route table information> was not deallocated.
RMON_IPADDRMGR_ENTRY_DEALLOC_FAIL
903 Failed to allocate memory for
<route table information>
warning Memory for <route table information> was not allocated.
RMON_IPADDRMGR_MEM_ALLOC_FAIL
904 Failed to add entry <route table
information> entry may already
exist
warning Entry <route table information> was not added; it may exist
already.
RMON_IPADDR_ENTRY_ADD_FAIL
905 Failed to find entry <route table
information>
warning Entry <route table information> was not found.
RMON_IPADDRMGR_ENTRY_FIND_FAIL
906 Invalid route descriptor for
operation <route table
information>
warning The route descriptor is invalid.
RMON_IPADDRMGR_INVALID_ROUTEDESC
907 <slot> <memory location> <table
type> parity recovery <table
entry>
warning There has been a successful recovery from a parity error.
RMON_IPADDRMGR_PARITY_ERROR_RECOVERY
908 Failed to add neighbor timer entry
for rtDesc: <desc> timeout:
<time> vrf: <value> ipAddr: <ip-
addr>
warning This message is logged when out neighbor cache management
runs into a serious error and can’t add a timer queue entry. These
are used to manage the neighbor cache. The logged parameters
are the IP address of the neighbor cache entry that was affected.
RMON_IPADDRMGR_NUD_TIMER_ADD_FAIL
937 Fabric <mod-num> inserted info The indicated fabric module has been inserted into the chassis
for the first time (or first detected at boot).
928 Fabric <blade> active info The fabric blade is actively passing traffic.
RMON_CHASSIS_FABRIC_ACTIVE
929 Fabric <blade> removed warning The indicated fabric blade was removed from the chassis.
RMON_CHASSIS_FABRIC_REMOVE
# Message Severity Description