Event Log Message Reference Guide 2013/06

3
Event Log Messages
45 Unable to add port to vlan <vlan-
id>, not enough hw resources on
port <port-num>
warning The port was not added to the specified VLAN due to low
hardware resources on the port.
RMON_ACL_PORT_ADD_ERROR
46 Unable to add port to vlan <vlan-
id>, GVRP is enabled
warning The port was not added to the specified VLAN because GVRP is
enabled.
RMON_ACL_NO_CONFIG_GVRP
47 Unable to add port <port-num> to
trunk, ACL is configured on vlan
<vlan-id>
warning The port was not added to a dynamic trunk because an ACL is
already configured on the port. When an ACL is applied to a port,
the port does not support a dynamic trunk.
RMON_ACL_PORT_ADD_TRUNK_VLAN_ERROR
48 Unable to apply ACL <acl-name>
to port <port-num>, failed to add
entry <ace-num>
warning The ACL was not applied to the port and the ACE entry was not
added due to a lack of hardware resources.
RMON_ACL_WONT_FIT_PORT_ERROR
49 Unable to add port <port-num> to
trunk, ACL is configured on port.
warning The port was not added to the trunk because an ACL is configured
on the port.
RMON_ACL_PORT_ADD_TRUNK_PORT_ERROR
50 Unable to add ACL to port <port-
num>, an ACL is already
configured on this port
warning The ACL is not added to the port because an ACL is configured on
the port.
RMON_ACL_PORT_ADD_ERROR_ACL_CONFIG
51 Unable to modify ACL <acl-
name>, ACL is applied
warning The ACL name cannot be modified once it has been applied.
RMON_ACL_MODIFY_ERROR
52 Unable to delete ACL <acl-
name>, ACL is applied
warning The ACL cannot be deleted because it is applied.
RMON_ACL_DELETE_ERROR
53 Unable to apply ACL <acl-num>
to vlan <vid> in direction
<direction>, failed to add entry
<entry>
warning There was an error applying the ACL due to lack of hardware
resources.
RMON_ACL_VLAN_HW_RESOURCE_ERROR
54 Unable to apply ACL <acl-num>
to port <port-num> in direction
<direction>, failed to add entry
<entry-num>
warning There was an error applying the ACL because of insufficient
hardware resources.
RMON_ACL_PORT_HW_RESOURCE_ERROR
55 Unable to apply ACL <acl-num>,
failed to add entry <entry-num>,
max ACE limit reached
warning There was an error applying the ACL because the maximum ACE
limit for ACLs was reached.
RMON_ACL_MAX_ACE_ERROR
56 Spanning Tree Protocol enabled info The spanning tree protocol has been enabled.
RMON_STP_ENABLE
57 Spanning Tree Protocol disabled info The spanning tree protocol has been disabled.
RMON_STP_DISABLE
58 STP: stp max age should be >=
XXX
STP: stp fwd delay should be >=
XXX
warning The STP Max Age or Forward Delay parameter should be greater
than the value "XXX", where ‘ XXX’ is calculated by the switch.
RMON_STP_BAD_CONFIG
# Message Severity Description