Event Log Message Reference Guide 2013/06

92
Event Log Messages
4057 An over-current has been
detected on external power
supply.
warn Over current has been detected on the external power supply.
RMON_PPS_OVER_CURRENT_DET
4058 An overtemperature has been
detected on external power
supply.
warn The external power supply is over temperature.
RMON_PPS_OVER_TEMP_DET
4059 Main power rail on external
power supply has failed.
warn The main power rail on the external power supply has failed.
RMON_PPS_MAINPWR_RAIL_BAD
4060 Internal power supply failure
detected.
warn Internal power supply is bad.
RMON_PPS_IPS_BAD_DET
4061 External power supply ready info The external power supply is ready.
RMON_PPS_READY
4062 Unsupported power supply
confiugrations detected on
external power supply
info Unsupported power supply configurations are detected on the
external power supply.
RMON_PPS_PSU_UNSUPPORTED
4063 Hotswap controller is now in
<state> state.
info The external power supply port is now in <enabled/disabled/auto-
recovery disabled/auto-recovery enabled> state.
RMON_PPS_HSC_CTRL_CHANGE
4064 Unable to restor external power
supply to factory default as
requested. Reason: <reason>.
info The external power supply cannot be restored to the factory
default.
RMON_PPS_FAC_RESET_FAIL
4065 Mailbox on external power
supply is <status> by <status>
info The external power supply zone record status: <status>.
RMON_PPS_MAILBOX_STATUS
4066 Low priority power reduction
completed.
info Can be either:
“External power supply power reduction completed”
or
“External power supply power reduction not required”.
RMON_PPS_ALLOC_PWR_REDUCED
4067 Unable to reduce low priority
power as requested. Reason:
<reason>.
info The low priority power reduction was unsuccessful.
RMON_PPS_ALLOC_PWR_DROP_FAIL
4068 Unable to enable or disable
hotswap controller as requested.
info Unable to control external power supply port <cable> as
requested.
RMON_PPS_HSC_CMD_FAIL
4069 External power supply info
<message>
info External power supply information. QA-only log message.
RMON_PPS_XPS_INFO
# Message Severity Description