HP 560 Wireless 802.11n Access Point Installation Guide

Figure 6 Retention screw and padlock bracket
4. Cable lock hole1. AP bracket
5. AP padlock bracket2. Retention screw
6. Padlock hole3. AP bracket lock tab
Removing the AP
To remove the AP from the bracket:
• Remove any locks and remove the retaining screw.
1. While carefully holding the AP, insert a flat screwdriver into the cable channel between
the channel wall and the AP bracket latch, releasing the AP from the bracket, while being
careful to retain grip on the AP as you slide it away from the AP bracket lock tab.
2. Disconnect the Ethernet cable from the AP.
Removing the AP 11