HP 560 Wireless 802.11n Access Point Installation Guide

Figure 2 Back view
4. Cable channel1. Ethernet port
5. Reset button2. Console port
3. AP bracket tab slot
Ports
The following ports are located on the back of the HP 560 as shown in Figure 2 (page 5):
• Ethernet port: Auto-sensing 10/100/1000 BaseT Ethernet port with RJ-45 connector. The port
supports IEEE 802.3af and 802.3at Power over Ethernet (PoE).
• Console port: A standard serial port with RJ-45 connector. To connect to a computer, use a
standard serial cable. For more information, see “Console Ports” in the Controller Configuration
and Administration Guide for your product.
Radios
The HP 560 features two radios:
• Radio 1: 5 GHz 802.11a/n/ac
• Radio 2: 2.4 GHz 802.11b/g/n
Antennas
The HP 560 contains two 3-element MIMO antennas.
Reset button
The reset button is accessible via a hole at the back of the AP. To reset the AP, insert a paper clip
into the Reset button hole, and press and quickly release the button. To reset the AP to factory
defaults, press and hold the button until the status LEDs flash three times, and then release.
Ports 5