HP Fixed Cord Power Distribution Unit and Extension Bars Installation Instructions

Installing the Control Unit
Installing the 0U Brackets
Installing in a Square-Holed Rail
NOTE: Use the M6 screw and cagenut that shipped with
the rack when installing in a square-holed rail.
Installing in a Square- and Round-Holed
Rail
NOTE: Use the sheetmetal mounting screw that is
included with this kit when installing in a square- and
round-holed rail.
Installing the 1U Brackets
Installing the Extension Bars
NOTE: Follow these same instructions when using a
single-wide extension bar bracket.
NOTE: The power indicator brightness might vary with
line voltage.
Connecting the Ground Bonding
Cable
The ground bonding screw is provided as an attachment point
for conductors. Use a ground bonding cable if the rack contains
any conductors for the purpose of functional grounding or
bonding of ungrounded metal parts.
The ground cable is not included.
Connecting Devices
When connecting devices, distribute the loads evenly to remain
within the capability of the extension bars and control unit.
Checking the Circuit Breakers
If power to a device is interrupted, check the circuit breakers
and reset if necessary. If power is still not restored, contact your
HP authorized service representative.