SuperStack II Advanced RPS Management Module User Guide

DUA1608-0AAA01
Command Line Interface 3-11
Changing the Configuration Fields
The first fields you must configure depend on the method of
network connection that you are using. For Ethernet, you need to
configure the IP address, Subnet mask and Default Router. For
SLIP, you need to configure the SLIP address and SLIP mask.
To change the value of a setup option, enter the command (or
abbreviation) followed by the new value. If you enter a command
without a new value or an invalid value, an error message is
displayed. For example, to change the IP address, enter:
IP a.b.c.d
where
a
,
b
,
c
and
d
are numbers between 0 and 255. To display
the new value, use the
Display
command.
For the changes to become effective, the module must be reset
using the RESET command. You are recommended to log on to the
Management Module again to ensure that the new addresses are
correct.
The configuration settings you can change are described in the
following sections.
IP Address
To change the IP address, type
IPA
followed by a space and the
new address assigned to the Management Module.
Use the format
a.b.c.d
, where
a
,
b
,
c
and
d
are numbers between
0 and 255. If you type a number that is not in this range, an error
message appears. The default IP address is 0.0.0.0 .
If you do not know the IP address to use, contact your network
administrator.
Press [Enter] to save the new setting.