SuperStack II Advanced RPS Management Module User Guide

DUA1608-0AAA01
3-12
C
HAPTER
3: C
ONFIGURING
T
HE
M
ANAGEMENT
M
ODULE
Subnet Mask
To change the Subnet mask value, type
SUB
followed by a space
and the Subnet mask value.
Use the format
a.b.c.d
, where
a
,
b
,
c
and
d
are numbers between
0 and 255. If you type a number that is not in this range, an error
message appears. If your local network is partitioned into subnets,
be sure to set this value to show that (for example, 255.255.0.0).
The default Subnet mask is 0.0.0.0 .
If you do not know the Subnet mask value to use, contact your
network administrator.
Press [Enter] to save the new setting.
Default Router
To change the default router, type
DEF
followed by a space and
the default router’s IP address. The default router is the default
destination for all packets not addressed to the local network
segment. This address
must
be set if you have routers in your
network.
Use the format
a.b.c.d
, where
a
,
b
,
c
and
d
are numbers between
0 and 255. If you type a number that is not in this range, an error
message appears. If there is no primary gateway, type
DEF
0.0.0.0
. The default router’s IP address is 0.0.0.0 .
If you do not know the default router to use, contact your network
administrator.
Press [Enter] to save the new setting.