SuperStack II Advanced RPS Management Module User Guide

DUA1608-0AAA01
3-14
C
HAPTER
3: C
ONFIGURING
T
HE
M
ANAGEMENT
M
ODULE
The default Trap address is 0.0.0.0, which disables Traps. Any
change to the default results in Traps being sent to the newly
specified Trap address.
To change the Trap destination, type
TRA
followed by a space and
the new address for the Traps. This should be the IP address of
your Network Management Station.
Use the format
a.b.c.d
, where
a, b, c
and
d
are numbers between
0 and 255. If you type a number that is not in this range, an error
message appears.
Press [Enter] to save the new setting.
Software Upgrade
The Management Module has the ability to accept a new version
of its software. If a new version is released, instructions for
downloading it to the Module will be contained in the software.
The latest version of the software can be found on a 3Com bulletin
board or the World Wide Web page, details of which are in
Appendix C, “Technical Support”.
Exiting the Configuration Program
For the changes to become effective, the module must be reset
using the RESET command. You are recommended to log on to the
Management Module again to ensure that the new addresses are
correct.
Enter
LO
. This will return you to the login prompt.