Opacity Shield Kit (JG561A) FIPS Enclosure Installation Guide

Installation tools
Introduction to the opacity shield kit
The installation tools are not provided with the switch. Prepare them yourself.
Phillips
screwdriver
ESD-preventive
wrist strap
Spanner
Applicable products
HP 5800-48G-PoE+ Switch with 2 Interface Slots (JC101A)
HP 5820X-14XG-SFP+ Switch with 2 Interface Slots (JC106A)
Alcohol-based
cleaning pad
M4 hex bolt
(1 for the left-side opacity
shield and 2 for the right-
side opacity shield)
M3 countersunk-head
screw (used to secure
the opacity shields, 3
for each opacity shield)
Tamper evidence
label (30 in total)
Left-side opacity shield
(1 in total)
Right-side opacity shield
(1 in total)
M3 hex bolt
(2 for the left-side opacity
shield and 1 for the right-
side opacity shield)
Installation preparation
The installation procedures must be performed by qualified personnel.
Before installation, read the Compliance and Safety Manual for the compatible switch
of the opacity shield kit.
Make sure the operating temperature is not higher than 40°C (104°F).
Wear an ESD-preventive wrist strap, and make sure the wrist strap makes good skin
contact and is well grounded.
HP 5800 and 5820X switches meet the requirement of FIPS security level 2.