Opacity Shield Kit (JG562A) FIPS Enclosure Installation

Installation tools
Introduction to the opacity shield kit
The installation tools are not provided with the switch. Prepare them yourself.
Phillips
screwdriver
ESD-preventive wrist
strap
Spanner
Applicable products
HP 5800-24G-SFP Switch with 1 Interface Slot (JC103A)
Alcohol-based
cleaning pad
Tamper
evidence label
(30 in total)
Left-side
opacity shield
(1 in total)
Right-side
opacity shield
(1 in total)
The installation procedures must be performed by qualified personnel.
Before installation, read the Compliance and Safety Manual for the compatible switch
of the opacity shield kit.
Make sure the operating temperature is not higher than 40°C (104°F).
Wear an ESD-preventive wrist strap, and make sure the wrist strap makes good skin
contact and is well grounded.
The two-holed mounting brackets are not designed to support the weight of the switch.
To mount the switch to the rack, install a rack shelf in a proper position of the rack,
move the switch on the rack shelf, and use screws to secure the two-holed mounting
brackets to the rack posts.
Two-holed
mounting bracket
(2 in total)
M4 countersunk-
head screw (used to
secure the mounting
brackets, 4 in total)
Hex bolt
(3 for each
opacity shield)
M3 countersunk-head
screw (used to secure the
opacity shields, 3 for
each opacity shield)
Installation preparation
HP 5800 switches meet the requirement of FIPS security level 2.
The mounting bracket is installed
at the port side of the chassis.
The mounting bracket is installed at
the power supply side of the chassis.
M3 countersunk-
head screw
Hex bolt
M4 countersunk-
head screw
M3 countersunk-
head screw
Hex bolt
M4 countersunk-
head screw
The mounting bracket is installed
at the port side of the chassis.
The mounting bracket is installed at
the power supply side of the chassis.
M4 countersunk-
head screw
M3
countersunk-
head screw
Use the
left screw
hole
Hex bolt
M4 countersunk-
head screw
M3
countersunk-
head screw
Use the
right screw
hole
Hex bolt
Only use the screws and hex bolts that are supplied in the opacity shield kit to secure the
opacity shield.
Installing the opacity shields
Installing the right-side opacity shield
Installing the left-side opacity shield