Opacity Shield Kit (JG563A) FIPS Enclosure Installation

Installing the opacity shield

Make sure the chassis temperature is above 10°C (50°F).

Before applying tamper evidence labels, use alcohol-based cleaning pads to clean the

chassis and air dry the cohesive areas.

Apply tamper evidence labels to all field replacement units

(for example, opacity shields and interface cards), USB ports, and any M3

countersunk-head screw on an opacity shield.

The methods for applying tamper evidence labels are the same when the mounting

brackets are installed at the port side and the power supply side. In the following

example, the mounting brackets are installed at the port side.

Applying tamper evidence labels

The mounting bracket is installed

at the port side of the chassis.

The mounting bracket is installed at

the power supply side of the chassis.

M3 countersunk-

head screw

M4 countersunk-

head screw

Hex bolt

M4 countersunk-head screw

Hex bolt

M3 countersunk-

head screw

Applying tamper evidence labels (chassis front view)

The methods for installing the opacity shields to an HP 5800-24G Switch and an HP

5800-48G Switch with 1 Interface Slot are the same. This section uses an HP 5800-

24G Switch as an example.

Only use the screws and hex bolts that are supplied in the opacity shield kit to secure

the opacity shield.

PAGE 1
Installing the opacity shield The methods for installing the opacity shields to an HP 5800-24G Switch and an HP 5800-48G Switch with 1 Interface Slot are the same. This section uses an HP 580024G Switch as an example. Only use the screws and hex bolts that are supplied in the opacity shield kit to secure the opacity shield. M4 countersunk-head screw Hex bolt M3 countersunkhead screw M4 countersunkhead screw The mounting bracket is installed at the port side of the chassis.