Opacity Shield Kit (JG564A) FIPS Enclosure Installation Guide

Installation tools
Introduction to the opacity shield kit
The installation tools are not provided with the switch. Prepare them yourself.
Phillips
screwdriver
ESD-preventive wrist
strap
Spanner
Applicable products
HP 5820X-24XG-SFP+ Switch (JC102A)
Alcohol-based
cleaning pad
Hex bolt
(8 in total)
M3 countersunk-head screw
(used to secure the opacity
shields, 8 in total)
Tamper evidence
label (30 in total)
Opacity shield
(2 in total)
The installation procedures must be performed by qualified personnel.
Before installation, read the Compliance and Safety Manual for the compatible
switch of the opacity shield kit.
Make sure the operating temperature is not higher than 40°C (104°F).
Wear an ESD-preventive wrist strap, and make sure the wrist strap makes good
skin contact and is well grounded.
The two-holed mounting brackets are not designed to support the weight of the
switch. To mount the switch to the rack, install a rack shelf in a proper position of
the rack, place the switch on the rack shelf, and use screws to secure the two-
holed mounting brackets to the rack posts.
If mounting brackets are installed near the power supplies, you can use the four-
holed mounting brackets that are supplied with the switch rather than a rack shelf
to mount the switch to the rack.
Two-holed
mounting bracket
(2 in total)
M4 countersunk-head screw
(used to secure the mounting
brackets, 4 in total)
Installation preparation
HP 5820X switches meet the requirement of FIPS security level 2.
The mounting bracket is installed near
the network ports of the chassis.
The mounting bracket is installed near
the power supplies of the chassis.
The mounting bracket is installed near the network ports of the chassis.
M3
countersunk-
head screw
Hex bolt
M4
countersunk-
head screw
Hex bolt
M3 countersunk-
head screw
M4 countersunk-head screw
Hex bolt
M3 countersunk-
head screw
M4
countersunk-
head screw
Only use the screws and hex bolts that are supplied in the opacity shield kit to secure
the opacity shield.
Installing the opacity shields
Installing the right-side opacity shield
Installing the left-side opacity shield