HP 6G Virtual SAS Manager User Guide

Example 3: The following example displays the results of the show command for an HP BladeSystem
enclosure when the config parameter is specified.
=> bladeenclosure location=local show config
Blade Enclosure at R20_top (SN: USE104690F)
Switch in Interconnect Bay: 5
Management Software Version: 2.0.1.0
Location: Local
Enclosure Logical ID: 500143801018C420
Zone Manager State: Ready
Redundancy State: VSM Active
Reset Needed after flash: No
SEP Flash deferred: No
Overall Status: OK
UID LED: OFF
Switch in Interconnect Bay: 6
Location: Remote
Enclosure Logical ID: 500143801018C378
Zone Manager State: Ready
Redundancy State: VSM Passive
Overall Status: OK
Blade Port: 1 (ProLiant BL460c G6)
Device Bay: 1
Mezzanine Slot: 2
Zone Groups: Ports_1
Blade Port: 2 (Not Connected)
Blade Port: 3 (Not Connected)
Blade Port: 4 (Not Connected)
Blade Port: 5 (Not Connected)
Blade Port: 6 (Not Connected)
Blade Port: 7 (Not Connected)
Blade Port: 8 (Not Connected)
Blade Port: 9 (Not Connected)
Blade Port: 10 (Not Connected)
Blade Port: 11 (Not Connected)
Blade Port: 12 (Not Connected)
Blade Port: 13 (Not Connected)
Blade Port: 14 (Not Connected)
Blade Port: 15 (Not Connected)
Blade Port: 16 (Not Connected)
Zone Group: Ports_1 (Assigned, Offline)
SAS Switch Port: 51(Ports_1)
SAS Switch Port: 52(Not Zoned)
SAS Switch Port: 53(Not Zoned)
SAS Switch Port: 54(Not Zoned)
SAS Switch Port: 55(Not Zoned)
SAS Switch Port: 56(Not Zoned)
SAS Switch Port: 57(Not Zoned)
SAS Switch Port: 58(Not Zoned)
SAS Switch Port: 61(Ports_1)
SAS Switch Port: 62(Not Zoned)
SAS Switch Port: 63(Not Zoned)
SAS Switch Port: 64(Not Zoned)
SAS Switch Port: 65(Not Zoned)
SAS Switch Port: 66(Not Zoned)
SAS Switch Port: 67(Not Zoned)
SAS Switch Port: 68(Not Zoned)
Storage Enclosure: HP MDS600 Disk System, PortBox=51:1,61:1 (OK)
Storage Enclosure: HP D2600 Disk Enclosure, PortBox=52:1,62:1 (OK)
The show command 61