F3215-HP Load Balancing Module High Availability Command Reference-6PW101

98
[Sysname-nqa-admin-test] type udp-jitter
[Sysname-nqa-admin-test-udp-jitter] reaction 1 checked-element jitter-ds threshold-type
average threshold-value 50 5 action-type trap-only
# Create reaction entry 2 for monitoring the destination-to-source jitter of UDP jitter probe packets. Set
the upper threshold to 50 milliseconds, and the lower threshold to 5 milliseconds. Before the NQA
operation starts, the initial state of the reaction entry is invalid. After the operation, the
destination-to-source jitter is checked against the threshold range. If the total number of threshold
violations exceeds 100 (included), the state of the entry is set to over-threshold. Otherwise, the state of the
entry is set to below-threshold. Once the state of the reaction entry changes, a trap message is generated
and sent to the NMS.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type udp-jitter
[Sysname-nqa-admin-test-udp-jitter] reaction 2 checked-element jitter-ds threshold-type
accumulate 100 threshold-value 50 5 action-type trap-only
reaction checked-element mos
Use reaction checked-element mos to configure a reaction entry for monitoring the MOS value in the
NQA operation. You cannot edit a reaction entry. To change the attributes in a reaction entry, use undo
reaction to delete the entry first and then configure a new one.
Use undo reaction to delete the specified reaction entry.
Syntax
reaction item-number checked-element mos threshold-value upper-threshold lower-threshold
[ action-type { none | trap-only } ]
undo reaction item-number
Default
No reaction entry for monitoring the MOS value is configured.
Views
Voice operation view
Default command level
2: System level
Parameters
item-number: Specifies a reaction entry ID in the range of 1 to 10.
threshold-value: Specifies threshold values.
upper-threshold: Specifies the upper threshold in the range of 1 to 500.
lower-threshold: Specifies the lower threshold in the range of 1 to 500. It must not be greater than the
upper threshold.
action-type: Specifies what action to be triggered. The default action is none.
none: Specifies the action of only displaying results on the terminal display.
trap-only: Specifies the action of displaying results on the terminal display and meanwhile sending
SNMP trap messages to the NMS.