F3215-HP Load Balancing Module High Availability Command Reference-6PW101

108
Views
DLSw operation view, DNS operation view, FTP operation view, HTTP operation view, ICMP echo
operation view, SNMP operation view, TCP operation view, UDP echo operation view, UDP jitter
operation view, voice operation view
Default command level
2: System level
Usage guidelines
When the routing table bypass function is enabled, the routing table is not searched, and the packet is
sent directly to the destination in a directly connected network.
Examples
# Enable the routing table bypass function.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] route-option bypass-route
source interface
Use source interface to configure the source interface for ICMP echo request packets. The ICMP echo
request packets take the primary IP address of the source interface as their source IP address when no
source IP address is specified. The specified source interface must be up. Otherwise, no ICMP echo
requests can be sent out.
Use undo source interface to restore the default.
Syntax
source interface interface-type interface-number
undo source interface
Default
No source interface is configured for ICMP echo request packets.
Views
ICMP echo operation view
Default command level
2: System level
Parameters
interface-type interface-number: Specifies an interface by its type and number.
Usage guidelines
If you configure both the source interface command and the source ip command, the source ip command
takes effect.
Examples
# Specify the primary IP address of interface GigabitEthernet 0/1 as the source IP address of ICMP echo
request packets.
<Sysname> system-view