F3215-HP Load Balancing Module High Availability Command Reference-6PW101

109
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] source interface gigabitethernet 0/1
Related commands
source ip
source ip
Use source ip to configure the source IP address of probe packets. The specified source IP address must
be the IP address of a local interface. The local interface must be up. Otherwise, no probe packets can
be sent out.
Use undo source ip to remove the configured source address. The primary IP address of the interface that
sends a probe packet serves as the source IP address of the probe packet.
Syntax
source ip ip-address
undo source ip
Default
No source IP address is configured for probe packets.
Views
DLSw operation view, FTP operation view, HTTP operation view, ICMP echo operation view, SNMP
operation view, TCP operation view, UDP echo operation view, UDP jitter operation view, voice operation
view
Default command level
2: System level
Parameters
ip-address: Specifies the source IP address of the operation.
Usage guidelines
If you configure both the source interface command and the source ip command, the source ip command
takes effect.
If you configure the source interface command but not the source ip command for ICMP echo operation,
the IP address of source interface is used as the source IP address of the ICMP echo request packet.
Examples
# Configure the source IP address of the ICMP echo packets as 10.1.1.1.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] source ip 10.1.1.1
Related commands
source interface