F3215-HP Load Balancing Module High Availability Command Reference-6PW101

127
Parameters
interval: Specifies flow check interval, which ranges from 30 to 600 seconds.
Usage guidelines
Use this command after standby interfaces are specified.
Examples
# Configure load balancing, backup bandwidth and flow check interval on interface GigabitEthernet
0/1 as 60 seconds.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] standby timer flow-check 60
Related commands
standby interface
standby timer startup
Use standby timer startup to set the delay timer for the backup function to take effect on system startup.
Use undo standby timer startup to restore the default.
Syntax
standby timer startup seconds
undo standby timer startup
Default
The backup function takes effect after a delay of 30 seconds.
Views
System view
Default command level
2: System level
Parameters
seconds: Specifies the delay timer for the backup function to take effect on system startup, which ranges
from 0 to 65535 seconds.
Usage guidelines
This command takes effect on all standby interfaces working in active/backup mode, and does not take
effect on the standby interfaces working in load balancing mode.
Examples
# Set the delay timer for the backup function to take effect on system startup to 40 seconds.
<Sysname> system-view
[Sysname] standby timer startup 40
standby track
Use standby track to associate an interface with a track entry.
Use undo standby track to remove the association.