F3215-HP Load Balancing Module High Availability Command Reference-6PW101

The track entry specified in this command can be nonexistent. You can use the vrrp ipv6 vrid weight track

command to specify a track entry, and then create the track entry with the track command.

If the weight of a VF owner is higher than or equal to the lower limit of failure, the priority of the VF owner

is always 255 and does not change with the weight value. Therefore, when an uplink fails, another VF

takes over the VF owner and becomes the AVF only when the weight of the VF owner decreases by a

properly specified value and becomes lower than the lower limit of failure, which means the weight of the

VF owner decreases by more than 245.

For more information about track entries, see High Availability Configuration Guide.

Examples

# Configure to monitor track entry 1, making the weights of VFs that belong to VRRP group 1 on

GigabitEthernet 0/1 decrease by 50 when track entry 1 turns to negative.

<Sysname> system-view

[Sysname] interface gigabitethernet0/1

[Sysname-GigabitEthernet0/1] vrrp ipv6 vrid 1 virtual-ip fe80::2 link-local

[Sysname-GigabitEthernet0/1] vrrp ipv6 vrid 1 weight track 1 reduced 50

Related commands

display vrrp ipv6