F3215-HP Load Balancing Module High Availability Command Reference-6PW101

1
VRRP configuration commands
The interfaces that VRRP involves can only be Layer 3 Ethernet interfaces and subinterfaces and VLAN
interfaces unless otherwise specified.
Common VRRP configuration commands
vrrp mode
Use vrrp mode to configure the VRRP working mode.
Use undo vrrp mode to restore the default.
Syntax
vrrp mode load-balance
undo vrrp mode
Default
VRRP operates in standard mode.
Views
System view
Default command level
2: System level
Parameters
load-balance: Specifies the load balancing mode.
Usage guidelines
• When you configure the working mode of VRRP by using this command, both IPv4-based and
IPv6-based VRRP groups operate in the specified mode.
• When VRRP operates in load balancing mode, the virtual IP address cannot be the same as the IP
address of any interface in the VRRP group, and the virtual IP address should be mapped to the
virtual MAC address. Otherwise, VRRP cannot operate in load balancing mode.
• When a VRRP group is created, you can still change the VRRP working mode. When you change
the VRRP working mode, all VRRP groups on the device operate in the specified mode.
Examples
# Configure VRRP to operate in load balancing mode.
<Sysname> system-view
[Sysname] vrrp mode load-balance
Related commands
• display vrrp
• display vrrp ipv6