F3215-HP Load Balancing Module Network Management Command Reference-6PW101

5
Output:0 packets, 0 bytes, 0 buffers
0 broadcasts, 0 multicasts, 0 pauses
0 errors, 0 underruns, 0 collisions
0 deferred, 0 lost carriers
# Display information about Layer 3 interface GigabitEthernet 0/1, which includes only the interface
name and traffic statistics.
<Sysname> display interface gigabitethernet 0/1 | include current state:|bytes
GigabitEthernet0/1 current state: DOWN ( Administratively )
Line protocol current state: DOWN
Peak value of input: 52859736 bytes/sec, at 2013-1-23 17:11:42
Peak value of output: 236108 bytes/sec, at 2013-1-23 17:11:42
Last 300 seconds input rate 0.00 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate 0.00 bytes/sec, 0 bits/sec, 0 packets/sec
Input: 0 packets, 0 bytes, 0 buffers
Output:0 packets, 0 bytes, 0 buffers
Table 1 Command output
Field Descri
p
tion
GigabitEthernet0/1 current
state
State of the Ethernet interface:
• DOWN ( Administratively )—The Ethernet interface was shut down with
the shutdown command. The interface is administratively down.
• DOWN ( Link-Aggregation interface down )—The Ethernet interface is
physically down because the aggregate interface corresponding to the
aggregation group to which the Ethernet interface belongs was shut
down with the shutdown command.
• DOWN—The Ethernet interface is administratively up but physically
down (possibly because no physical link is present or the link has failed).
• UP—The Ethernet interface is both administratively and physically up.
Line protocol current state
Link layer state of the interface:
• DOWN—The interface is physically down.
• UP—The interface is physically up.
Internet protocol processing
Disabled indicates that IP packets cannot be processed.
For an interface configured with an IP address, this field changes to Internet
Address is.
Media type is Physical medium, twisted pair or optical fiber.
loopback not set
The loopback testing function is disabled.
For an interface configured with the loopback external or loopback internal
command, this field changes to loopback is set.
promiscuous mode not set The interface is operating in non-promiscuous mode.
Peak value of input Peak value of input traffic in Bps.
Peak value of output Peak value of output traffic in Bps.
at Time when the peak rate occurs.
Last clearing of counters
Time when the reset counters interface command was last used to clear the
interface statistics. If the command was never used since the device was
started, this field displays Never.