F3215-HP Load Balancing Module Network Management Command Reference-6PW101

7
Field Descri
p
tion
Line protocol current state
Link layer state of the subinterface:
• DOWN—The interface is physically down.
• UP—The interface is physically up.
Internet protocol processing
Disabled indicates that IP packets cannot be processed.
For an interface configured with an IP address, this field changes to
Internet Address is.
IP Packet Frame Type Encapsulation format for IPv4 packets.
Hardware Address MAC address corresponding to the subinterface.
IPv6 Packet Frame Type Encapsulation format for IPv6 packets.
Last clearing of counters
Time when the reset counters interface command was last used to clear
statistics on the subinterface.
If the command was never used since the device was started, this field
displays Never.
Input Input packet statistics.
Output Output packet statistics.
# Display detailed information about Layer 2 interface GigabitEthernet 0/1.
<Sysname> display interface gigabitethernet 0/1
GigabitEthernet0/1 current state: UP
IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 0000-000f-0007
Description: GigabitEthernet0/1 Interface
Loopback is not set
Media type is twisted pair, port hardware type is 100_BASE_TX
100Mbps-speed mode, half-duplex mode
Link speed type is autonegotiation, link duplex type is autonegotiation
Flow-control is not enabled
The Maximum Frame Length is 1536
Broadcast MAX-ratio: 100%
Multicast MAX-ratio: 100%
PVID: 999
Mdi type: auto
Port link-type: access
Tagged VLAN ID : none
Untagged VLAN ID : 999
Port priority: 0
Last clearing of counters: Never
Last 300 seconds input: 0 packets/sec 74 bytes/sec 0%
Last 300 seconds output: 0 packets/sec 12 bytes/sec 0%
Input (total): 21322 packets, 1748554 bytes
- unicasts, - broadcasts, - multicasts, - pauses
Input (normal): 21322 packets, - bytes
1268 unicasts, 7560 broadcasts, 12494 multicasts, 0 pauses
Input: 0 input errors, 0 runts, 0 giants, - throttles
0 CRC, - frame, - overruns, - aborts
- ignored, - parity errors