F3215-HP Load Balancing Module Network Management Command Reference-6PW101

210
Views
OSPF view
Default command level
2: System level
Parameters
config: Enables configuration logging.
error: Enables error logging.
state: Enables state logging.
Usage guidelines
If no keyword is specified, the command enables all logging.
Examples
# Enable OSPF logging.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] enable log
filter
NOTE:
This command is only available on an ABR.
Use filter to configure OSPF to filter inbound/outbound Type-3 LSAs on an ABR.
Use undo filter to disable Type-3 LSA filtering.
Syntax
filter { acl-number | ip-prefix ip-prefix-name } { export | import }
undo filter { export | import }
Default
Type-3 LSAs filtering is disabled.
Views
OSPF area view
Default command level
2: System level
Parameters
acl-number: Specifies an ACL by its number, in the range of 2000 to 3999.
ip-prefix-name: Specifies an IP prefix list by its name, a string of 1 to 19 characters, to filter
inbound/outbound Type-3 LSAs. For more information about IP prefix lists, see Network Management
Configuration Guide.
export: Filters Type-3 LSAs advertised to other areas.
import: Filters Type-3 LSAs advertised into the local area.