F3215-HP Load Balancing Module Network Management Command Reference-6PW101

213
route-policy route-policy-name: Specifies a routing policy, a case-sensitive string of 1 to 63 case-sensitive
characters, to filter inbound routes. For more information about routing policy, see Network
Management Configuration Guide.
Usage guidelines
To reference an advanced ACL (with a number from 3000 to 3999) in the command, configure the ACL
in one of the following ways:
• To deny/permit a route with the specified destination, use the rule [ rule-id ] { deny | permit } ip
source sour-addr sour-wildcard command.
• To deny/permit a route with the specified destination and mask, use the rule [ rule-id ] { deny |
permit } ip source sour-addr sour-wildcard destination dest-addr dest-wildcard command.
The source keyword specifies the destination address of a route and the destination keyword specifies the
subnet mask of the route. The subnet mask must be contiguous. Otherwise, the configuration does not
take effect.
Examples
# Use ACL 2000 to filter inbound routes.
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule deny source 192.168.10.0 0.0.0.255
[Sysname-acl-basic-2000] quit
[Sysname] ospf 100
[Sysname-ospf-100] filter-policy 2000 import
# Configure ACL 3000 to permit only route 113.0.0.0/16 to pass. Use ACL 3000 to filter inbound routes.
<Sysname> system-view
[Sysname] acl number 3000
[Sysname-acl-adv-3000] rule 10 permit ip source 113.0.0.0 0 destination 255.255.0.0 0
[Sysname-acl-adv-3000] rule 100 deny ip
[Sysname-acl-adv-3000] quit
[Sysname] ospf 100
[Sysname-ospf-100] filter-policy 3000 import
host-advertise
Use host-advertise to advertise a host route.
Use undo host-advertise to remove a host route.
Syntax
host-advertise ip-address cost
undo host-advertise ip-address
Default
No host route is advertised.
Views
OSPF area view
Default command level
2: System level