F3215-HP Load Balancing Module Network Management Command Reference-6PW101

239
To configure an area as a stub area, issue the stub command on all routers attached to the area.
Examples
# Configure Area 1 as a stub area.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] area 1
[Sysname-ospf-100-area-0.0.0.1] stub
Related commands
default-cost
stub-router
Use stub-router to configure a router as a stub router.
Use undo stub-router to restore the default.
Syntax
stub-router
undo stub-router
Default
No router is configured as a stub router.
Views
OSPF view
Default command level
2: System level
Usage guidelines
The router LSAs sent by the stub router over different links contain different link type values. A value of 3
represents a link to a stub network, and the cost of the link is not changed. A value of 1, 2 or 4 represents
a point-to-point link, a link to a transit network, or a virtual link, and the cost of such links is set to 65535.
Neighbors on such links will not send packets to the stub router as long as they have a route with a
smaller cost.
Examples
# Configure the router as a stub router.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] stub-router
transmit-pacing
Use transmit-pacing to configure the maximum number of LSU packets that can be sent every the
specified interval.
Use undo transmit-pacing to restore the default.
Syntax
transmit-pacing interval interval count count