F3215-HP Load Balancing Module Network Management Command Reference-6PW101

278
all-processes: Redistributes routes from all the processes of the specified protocol. This keyword takes
effect only when the protocol is rip or ospf.
allow-direct: Redistributes direct routes from the specified protocol. This keyword is available only when
the specified protocol is OSPF. Without this keyword, BGP does not redistribute direct routes from OSPF.
If you specify the route-policy route-policy-name keyword together with the allow-direct keyword, make
sure that no rule in the routing policy conflicts with any direct route. For example, do not configure the
if-match route-type command for the routing policy to filter OSPF routes. Otherwise, the allow-direct
keyword does not take effect.
med-value: Specifies a MED value for redistributed routes, ranging from 0 to 4294967295. If the
argument is not specified, the cost of the redistributed route is used as its MED in the BGP routing domain.
route-policy-name: Name of a routing policy used to filter redistributed routes, a case-sensitive string of
1 to 63 characters.
Usage guidelines
Only active routes can be redistributed. You can use the display ip routing-table protocol command to
display route state information.
The ORIGIN attribute of routes redistributed with the import-route command is INCOMPLETE.
The undo import-route protocol all-processes command removes only the configuration made by the
import-route protocol all-processes command, instead of the configuration made by the import-route
protocol process-id command.
Examples
# In BGP view, redistribute routes from RIP process 1.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] import-route rip
log-peer-change
Use log-peer-change to enable the global BGP logging on peers going up and down.
Use undo log-peer-change to disable the function.
Syntax
log-peer-change
undo log-peer-change
Default
The function is enabled.
Views
BGP view
Default command level
2: System level
Examples
# Enable BGP logging on peers going up and down.
<Sysname> system-view
[Sysname] bgp 100