F3215-HP Load Balancing Module Network Management Command Reference-6PW101

304
route-policy-name: Routing policy name, a case-sensitive string of 1 to 63 characters. Using the routing
policy can set a preference for routes matching it. The default value applies to routes not matching the
routing policy.
Usage guidelines
For external-preference, internal-preference, and local-preference, the greater the preference value is, the
lower the preference is, and the default values are 255, 255, and 130, respectively.
Examples
# In BGP view, configure preferences for EBGP, IBGP and local routes as 20, 20, and 200.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] preference 20 20 200
reflect between-clients (BGP view)
Use reflect between-clients to enable route reflection between clients.
Use undo reflect between-clients to disable this function.
Syntax
reflect between-clients
undo reflect between-clients
Default
Route reflection between clients is enabled.
Views
BGP view
Default command level
2: System level
Usage guidelines
After a route reflector is configured, it reflects the routes of a client to other clients. If the clients of a route
reflector are fully meshed, disable route reflection between clients to reduce routing costs.
Examples
# Disable route reflection between clients.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] undo reflect between-clients
Related commands
• peer reflect-client
• reflector cluster-id
reflector cluster-id (BGP view)
Use reflector cluster-id to configure the cluster ID of the route reflector.
Use undo reflector cluster-id to remove the configured cluster ID.