F3215-HP Load Balancing Module Network Management Command Reference-6PW101

305
Syntax
reflector cluster-id { cluster-id | ip-address }
undo reflector cluster-id
Default
Each route reflector uses its router ID as the cluster ID.
Views
BGP view
Default command level
2: System level
Parameters
cluster-id: Cluster ID in the format of an integer from 1 to 4294967295.
ip-address: Cluster ID in the format of an IPv4 address in dotted decimal notation.
Usage guidelines
Typically, a cluster has only one route reflector. The router ID of the route reflector is the ID of the cluster.
You can configure multiple route reflectors to improve network stability. Using this command can
configure the identical cluster ID for all the route reflectors to avoid routing loops.
Examples
# Set the cluster ID to 80.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] reflector cluster-id 80
Related commands
• peer reflect-client
• reflect between-clients
refresh bgp
Use refresh bgp to perform soft reset on specified BGP sessions.
Syntax
refresh bgp { ip-address | all | group group-name | external | internal } { export | import }
Views
User view
Default command level
1: Monitor level
Parameters
ip-address: Soft-resets the BGP session to a peer.
all: Soft-resets all BGP sessions.
group-name: Soft-resets sessions to a peer group, name of which is a sting of 1 to 47 characters.
external: EBGP session.