F3215-HP Load Balancing Module Network Management Command Reference-6PW101

308
<Sysname> reset bgp flap-info as-path-acl 10
reset bgp ipv4 all
Use reset bgp ipv4 all to reset all the BGP sessions of IPv4 unicast address family.
Syntax
reset bgp ipv4 all
Views
User view
Default command level
2: System level
Examples
# Reset all the BGP sessions of IPv4 unicast address family.
<Sysname> reset bgp ipv4 all
router id
Use router id to configure a global router ID.
Use undo router id to remove the global router ID.
Syntax
router id router-id
undo router id
Default
No global router ID is configured.
Views
System view
Default command level
2: System level
Parameters
router-id: Router ID, in the form of a dotted decimal IPv4 address.
Usage guidelines
Some routing protocols use a router ID to identify a device. You can configure a global router ID, which
is used by routing protocols that have no router ID configured.
If no global router ID is configured, the highest loopback interface IP address, if any, is used as the router
ID. If no loopback interface IP address is available, the highest physical interface IP address is used,
regardless of the interface status.
During an active/standby switchover, the standby main board checks whether the previous router ID that
is backed up before switchover is valid. If not, it selects a new router ID.
If the interface whose IP address is the router ID is removed or modified, a new router ID is selected.
Other events, (the interface goes down; after a physical interface address is selected as the router ID, an