F3215-HP Load Balancing Module Network Management Command Reference-6PW101

331
apply ip-precedence
Use apply ip-precedence to set a precedence for packets.
Use undo apply ip-precedence to remove the configuration.
Syntax
apply ip-precedence value
undo apply ip-precedence
Views
Policy node view
Default command level
2: System level
Parameters
value: Sets the precedence for IP packets. Eight precedence values (0 to 7) are available. Each
precedence value corresponds to a precedence type, as shown in Table 69. Yo
u can set either a
precedence value or a precedence type for IP packets.
Table 69 IP precedences and the corresponding types
Precedence value
Precedence t
yp
e
0 routine
1 priority
2 immediate
3 flash
4 flash-override
5 critical
6 internet
7 network
Examples
# Set the precedence to 5 (critical) for packets.
<Sysname> system-view
[Sysname] policy-based-route aa permit node 11
[Sysname-pbr-aa-11] apply ip-precedence critical
apply output-interface
Use apply output-interface to set output interfaces for packets.
Use undo apply output-interface to remove the configuration.
Syntax
apply output-interface interface-type interface-number [ track track-entry-number ] [ interface-type
interface-number [ track track-entry-number ] ]
undo apply output-interface [ interface-type interface-number [ interface-type interface-number ] ]