F3215-HP Load Balancing Module Network Management Command Reference-6PW101

20
Default command level
2: System level
Parameters
10: Sets the interface speed to 10 Mbps.
100: Sets the interface speed to 100 Mbps.
1000: Sets the interface speed to 1000 Mbps.
auto: Enables the interface to negotiate a speed with its peer.
Usage guidelines
For an Ethernet copper port, use the speed command to set its speed to match the speed of the peer
interface.
For a fiber port, use the speed command to set its speed to match the rate of a pluggable transceiver.
Examples
# Configure GigabitEthernet 0/1 to operate at 100 Mbps.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] speed 100
Related commands
speed auto
sub-interface rate-statistic
Use sub-interface rate-statistic to enable rate statistics collection for the subinterfaces of an Ethernet
interface.
Use undo sub-interface rate-statistic to disable rate statistics collection for the subinterfaces of an
Ethernet interface.
Syntax
sub-interface rate-statistic
undo sub-interface rate-statistic
Default
The system does not collect rate statistics for Ethernet subinterfaces.
Views
Ethernet interface view
Default command level
2: System level
Usage guidelines
Use this function with caution, because it requires a large amount of system resources.
Examples
# Enable rate statistics collection on the subinterfaces of GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1