F3215-HP Load Balancing Module Network Management Command Reference-6PW101

406
Views
Interface view
Default command level
2: System level
Parameters
process-id: RIPng process ID, in the range of 1 to 65535.
Examples
# Enable RIPng 100 on GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet0/1
[Sysname-GigabitEthernet0/1] ripng 100 enable
ripng metricin
Use ripng metricin to specify an additional metric for received RIPng routes.
Use undo ripng metricin to restore the default.
Syntax
ripng metricin value
undo ripng metricin
Default
The additional metric to received routes is 0.
Views
Interface view
Default command level
2: System level
Parameters
value: Additional metric for received routes, in the range of 0 to 16.
Examples
# Specify the additional routing metric as 12 for RIPng routes received by GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet0/1
[Sysname-GigabitEthernet0/1] ripng metricin 12
Related commands
ripng metricout
ripng metricout
Use ripng metricout to configure an additional metric for RIPng routes advertised by an interface.
Use undo rip metricout to restore the default.